Just a heads up, if you're new to UV DTF decals, the application process might take a bit of getting used to.

Here are some things to remember before you start:

Firstly, avoid using sublimation glasses, especially frosted, as the wrap might not stick well.

Secondly, skip the alcohol as it may break down the adhesive, so just wash your cup with soapy water and let it dry completely.

Lastly, once the adhesive touches the glass during application, it's not removable or adjustable because it's pretty strong.

 

Step 1:

Wash your cup with soap and make sure it's completely dry. Avoid alcohol as it breaks down the adhesive. Ensure the surface is free of dust and debris. Trim any excess clear carrier sheet around the design before applying to prevent overlapping. Wash your hands and make sure not to use any hand lotion before applying the decal.

Step 2:

Peel back about an inch of the backing on one side, then use scissors to cut off 1/2 inch of the backing, exposing the adhesive. Carefully wrap the decal around your cup using the unexposed part, being careful not to stick the exposed adhesive to the glass. Once you're satisfied with the placement, gently press down the exposed 1/2 inch of adhesive to secure the transfer. Place the cup on a flat surface, or for better results, use our silicone gradle. Then, as you rotate the cup, begin peeling off the backing and pressing the decal onto the glass. Once the decal is applied, take your time to firmly press it onto the surface with your palm, using body temperature to activate the adhesive. This will make peeling easier later and reduce lifting. You can also use a hairdryer on a low setting to help with the process. Squeegee with firm pressure over design.

Step 3:

Slowly peel off the clear carrier sheet from the decal, making sure it doesn't stretch or tear the transfer. If any part of the design lifts as you peel, push it back down and rab with your finger before continuing.

Step 4:

Use your fingers or the soft side of a squeegee to smooth out the decal, starting from the center and working outward. Apply firm pressure to seal the edges of the design.

Step 5:

Don't wash or use the finished project for 24-48 hours to allow the adhesive to cure on the cup.

Hope this helps! Feel free to reach out if you have any questions.

 

Please note that we're not liable for transfers that aren't applied correctly or get damaged during application. Unfortunately, we can't offer returns or exchanges in these cases.

ALL SALES ARE FINAL. NO CANCELATIONS.

All transfers are custom printed upon order. Due to the nature of these items, returns are not accepted unless they arrive damaged or defective. Refunds will not be issued for forced (unauthorized) returns.

For any defective or wrong items, please contact us  immediately. 

For more information on Returns and Refunds, please refer to our FAQ & Policies section!

Please note:

• Transfer dimensions are approximate.
• Colors of transfers may vary and may not match exactly. This is because every computer monitor has a different capability to display colors, and everyone sees these colors differently.